Meet the Challenger
TWO MODES. ONE SYSTEM.
Stand or sit. The Challenger is a rigid, three-piece modular paddle board that converts to a comfortable seated setup in seconds. Easy to transport, store and take anywhere.
Fast to water
No pump. No setup delays.
This rigid modular board assembles in minutes — just latch and go.
packs small but Plays big
Modular by design.
Breaks down for easy storage — no roof rack or garage required.
One Board with Two Ways to Ride
SUP or kayak — your call.
Switch modes in seconds. Accessories stow cleanly inside the board when you're done.
Engineered for performance.
Designed for convenience.
The Challenger combines the stability of a rigid stand-up paddle board with the versatility of seated paddling in one modular design.
Be paddle-ready in minutes with no tools or pumps required. Simply connect the three sections, secure the latches, and you're ready to go. The detachable top-mount fin installs once the board is afloat, helping protect the fin during transport and setup.
Keep smaller belongings close by and store them inside one of the three sealed storage compartments. When you're done paddling, select accessories stow conveniently inside the board.
- Rigid construction delivers stability and control
- Modular design packs small and carries easily
- Sets up in under 3 minutes without tools or a pump
- Top-mount fin installs after launch, protected during transport
- Three compartments hold essentials while on the water
- Shoulder strap, fin, leash and footrest stow neatly inside the board
- (1) Challenger 10' 2" Modular SUP/Kayak Hybrid
- (1) Convertible Paddle Set
- (1) Top-Mount Fin*
- (1) Shoulder Strap*
- (1) Ankle Leash*
- (1) Seat
- (1) Footrest
- (1) Water-Resistant Pouch*
- (1) 5/16 Wrench*
- (10) Latch Caps
- (4) Bungee Hooks
*Select accessories are securely packaged and stored inside the tail module’s built-in storage compartment. Simply remove the black rubber hatch cover to access them upon unboxing.
Board Dimensions
- Length: 10' 2"
- Width: 32"
- Thickness: 6"
- Weight: 44.04 lbs
- Weight Capacity: 230 lbs
Light enough to carry solo. Wide enough for real stability.
Section Dimensions
- Nose: 41.375" / 11.4 lbs
- Center: 44.625" / 20 lbs
- Tail: 40.375" / 12.64 lbs
Each section under 21 lbs — easy to lift and load.
Additional Specs
Material: High-density polyethylene (HDPE) — rigid, durable, and built for real use.
Setup Time: Under 3 minutes. No tools or pump required.
Storage: Largest piece measures 44.6″. Fits in most trunks and closets.
Design Origin: Patented modular system, made in North America
See How It Works
Are You Ready For the Challenger?
Visit our frequently asked questions page to learn more.
